How to Make a Hummingbird Feeder — Miniature Tutorial (1:12 scale)
I love using things that would normally hit the trash can. This project reminds me to look at familiar objects with fresh insight. For years I’ve tossed away the lids to the McDonald’s beverages. I was amazed when I looked carefully and noticed the raised icons. I can’t wait to see what I can do next with the other emblems!
Red nail polish or acrylic paint
Yellow nail polish or acrylic paint
Length of green floral wire (six inches)
A needle or something to poke a small hole with
Circle punch (preferably the same diameter as the straw
Tacky Quick Drying glue
Clear drinking straw
The plastic lid from McDonald’s cold beverage
Either–cardstock or air-dry clay
1. Locate the icon on the beverage that looks like a flower. Press air-dry class (such as DAS) into the icon and let dry. (Alternative: Cut out the flower. Glue it to cardstock. Cut out around it again.)
|In the eleven o’clock position on the lid, you can see the flower icon.|
2. When the icon is dry, paint it bright red. Add yellow dots to the flowers. (Tip: Use the end of a toothpick to make the dots perfect.)
3. Cut a length of the straw, about 1 inch long or so.
4. Cut a thin strip of red paper, about 3/8″ wide and an inch long. Glue it around the top of your length of plastic straw. Let dry.
5. Put out a circle from the red paper with your circle punch. (Alternative: Trace the end of a straw on red paper. Cut out the traced circle.)
6. Put a tiny hole in the middle of the red circle. Enlarge it until the green floral wire will fit inside. Bend the floral wire into an upside down letter “L”. Poke the shortest end into the hole in the red circle. Glue it to the red circle. You now have the cap of the lid and the wire stand.
7. Attach the red circle (cap of the lid and wire stand) to the top of the straw so that it meets the red strip of paper. Glue together. Coat with red nail polish.
8. Glue the flower to the bottom.